What is the suggested depth range for digging a hole when preparing for a standard percolation test?
Answer
One to two feet deep
The standard procedure for establishing a test basin involves digging a hole approximately one to two feet deep to get a measure representative of the root zone.
Related Questions
What is the speed of water movement through soil often referred to as?What is the key determinant influencing the speed at which rainwater travels through the ground once it soaks in?How do large, highly interconnected pores created by sand particles generally affect water movement?What effect do the tiny pore spaces formed by tightly packed clay particles have on drainage?Which soil composition typically describes soil that allows for sufficient moisture retention while letting excess water move out?What is the direct result of soil compaction on the pore spaces that govern water flow?What is the suggested depth range for digging a hole when preparing for a standard percolation test?Why must the soil be pre-wetted before timing the final drainage rate measurement in a percolation test?During the timing phase of the percolation test, how much of a drop in water level is measured to calculate the rate?What is the generally accepted drainage rate range considered ideal for supporting most vegetable gardens and ornamental plants?What is the primary adverse effect of soil that drains too quickly, such as pure coarse sand?If a percolation test shows a rate significantly below 0.5 inches per hour, what step is generally recommended before planting sensitive species?